Chemycal has been acquired by 3E
Learn MoreDiscover how Chemycal PRO helps you boosting your regulatory monitoring:
Title of document
Polypropylene Pipes (PP) Types 1, 2 And 3 General Quality Requirements and Testing PS: 4533 ICS No. 23.040.20 (21 page(s), in English)
Description
This Standard was adopted by Pakistan Standard & Quality Control Authority after recommendations of the Technical Committee for “BUILDER’S HARDWARE AND SANITARY FITTINGS” (BDC-06) on 1999. The same had been approved and endorsed by the Civil Engineering National Standards Committee (CENSC) on 06-12-1999.
This Standard has been prepared after taking into consideration the views and suggestions of the manufacturers, technologists, suppliers and utilizing agencies.
In preparation of this Standard the Technical Committee acknowledges with thanks the assistance drawn from the standard DIN 8078
Notifying member: Pakistan
Notification: G/TBT/N/PAK/153
Objective tag
Quality requirements
Objective
This standard specifies requirements and the relevant methods of test for seamless pipes of circular cross section made from propylene homopolymers (PP-H) (type 1), thermoplastic propylene impact copolymers (PP-B) (type 2) or thermoplastic propylene random copolymers (type 3).
Individual requirements specified in this standard may be omitted or supplemented in technical delivery conditions relating to particular applications
Agency responsible
Pakistan Standards & Quality Control Authority
WTO TBT National Enquiry Point
PSQCA Complex, Gulistan-e-Johar
Karachi, Pakistan
Tel.: (+92) 21 99261878
E-mail: [email protected]
Website: http://www.psqca.com.pk/
Timing:
2013 © MyChemicalMonitoring. ALL Rights Reserved. About Us | Terms and Conditions